![]() Press down and keep hold AUTO Mode Button on DEEBOT to power ONĭEEBOT failed to establish a connection with the Charging Dock If a user’s router set a 2.4G and 5G Wi-Fi at the same time, set the two frequencies for different SSID.Ĭonsidering the Wi-Fi connectivity, we should bet on this best robot vacuum for carpet suggestions that had multiple sensors to drive in the right way and adjust automatically. If it still does not work, break it down! Oh no, don’t take it seriously.Try to restart the router and the phone to connect the internet network again. ![]() Disconnect other additional user devices from the mobile Wi-Fi, mainly for Peer-to-Peer (P2P) Network downloads and online videos when connecting the robot.Do not minimize the background in the App when the network is going connect.Check if the Wi-Fi credentials are correct.Check if the phone is linked to the Wi-Fi and the Wi-Fi can communicate the internet normally.Place the robot towards the router where the wireless signal strength is powerful.The robot only supports 2.4G Wi-Fi but does not support 5G Wi-Fi and enterprise networks. ![]() The user device is not able to connect to the mobile Wi-Fi Manually by hand Place your DEEBOT N79 on the Charging Dock, disconnect after 3 minutes charging, repeat this process 3 times then charge normally. Solution: Replace and re-activate the battery. Possible Cause:The battery is fully discharged. Your DEEBOT N79 Keep on the Charging Dock to make sure it has a full battery charge to work at any time as needed. Solution: Ensure the robot’s side Bottom Power Switch is turned ON when Plugged in the Charging Dock. Possible Cause:Maybe Charging Dock is unplugged while the robot’s Bottom Power Switch is ON, which causes battery drain. If necessary, you can remove the robot yourself to connect. ![]() Solution: Confirm that DEEBOT N79 has made a connection with the Charging Dock Pins. Keep the immediate area 2m in front of the charger and 1 m on both sides of the charger clear of objects and reflective surfaces. Place the Charging Dock on a level floor surface against the wall with the base vertical to the ground. You probably do not know, Check the facts. Possible Cause:Maybe, DEEBOT N79 did not connect to the charging dock. DEEBOT is powered goes ON when Power Indicator light glows a continuous BLUE. You have to know “l” indicates ON and “O” indicates OFF. Solution: Turn the robot’s Side Power Switch to the ON position. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |